Standard equipment for M-CUT 1303 / M-CUT 2003 / M-CUT 2525:

• Manual backgauge with 750 mm stroke
• Squaring arm with ruler
• Foot pedal
• Front sheet holding arms
• Finger protection cages
• Rear protection cages with photocell
• Cutting unit counter
• Cutting line illumination

Optional equipment for M-CUT 1303 / M-CUT 2003 / M-CUT 2525:

• NC control backgauge with 750 mm stroke
• NC control backgauge with 1000 mm stroke
• Pneumatic thin sheet support system
• Rear protection cages with light barrier
• 0-180 ° angular cutting device
• Cutting line shadow illumination
• Elgo control unit
• Squaring arm and front sheet holding arms other than standard length
• Front operated manual back gauge with ball screw

Standard equipment for M-CUT 2004 / M-CUT 2504 / M-CUT 3004:

• NC control backgauge with 750 mm stroke
• Squaring arm with t slot, stoper and ruler
• Foot pedal
• Cutting unit counter
• Front sheet holding arms
• Finger protection cages
• Rear protection cages with photocell
• Table with ball transfer
• Cutting line illumination

Optional equipment for M-CUT 2004 / M-CUT 2504 / M-CUT 3004:

• NC control backgauge with 1000 mm stroke
• Pneumatic thin sheet support system
• Rear protection cages with light barrier
• 0-180° angular cutting device
• Cutting line shadow illumination
• Elgo control unit
• Squaring arm and front sheet holding arms other than standart length
• Front operated manuel back gauge with ball screw